ITCGM01B
IN-DASH STEREO INSTALLATION KIT FOR
2010-14 CHEVROLET CAMARO
WITH TOUCH-SCREEN INTERFACE
*Dash modification required*
LIABILITY DISCLAIMER
This instruction booklet is based on carefully documented data and research of automobile dash disassembly, wire harness/
codes and information pertaining to installation of this kit (ITCGM01B) in 2010-14 Chevrolet Camaro vehicles. Scosche Industries,
Inc. cannot be held responsible for discrepancies/inconsistencies that may occur due to the automobile manufacturing changes
or options, or damage that may occur in the automobile during the installation of components while using this booklet.
©2017 SCOSCHE INDUSTRIES, INC.
ITCGM01B 05/17
If you have any further questions, call our toll free technical help line at:
1-800-621-3695x3
INTRODUCTION/PRELIMINARY
This premium installation kit is for 2010-14 Chevrolet Camaro vehicles. Included are all the parts
you need to mount your car stereo or CD player into your vehicle’s dash. Refer to the individual
instruction in this manual to remove your vehicle’s factory radio and assemble the kit. *Dash
modification required see page 2
.
CAUTION
DISCONNECT YOUR VEHICLE’S NEGATIVE BATTERY TERMINAL BEFORE THE INSTALLATION
TO HELP PREVENT ELECTRICAL DAMAGE. WE RECOMMEND THE USE OF A VOLT/OHM
METER OVER A TEST LIGHT TO CHECK WIRING. A TEST LIGHT OR GROUNDED WIRE PROBE
CAN CAUSE DAMAGE TO THE VEHICLE’S COMPUTER AND/OR DIAGNOSTIC SYSTEMS. AVOID
ALL FACTORY AIRBAG WIRING - AIRBAGS CAN ACCIDENTALLY DEPLOY CAUSING SERIOUS
INJURY OR DEATH.
NOTES
• See your vehicle’s instructions for any special tools your installation might require.
• Read all instructions accompanying your car stereo for proper wiring and mounting instructions.
1. Main panel with built-in touch screen (
*
)
2. Hazard Warning Flasher
3. Stereo mounting bracket (left)
4. Stereo mounting bracket (right)
5. Dash pocket for single din mount
6. Power harness (not shown-see page 3)
SOLD SEPARATELY:
GMOSM1
OnStar Retention Interface
1
2
5
*
3
4
