HAQ02 ASSEMBLY
8. Connect the provided power !-harness
©,--------
according to the diagram displayed in
Female Connector to
To QI Module
the Test Connection box at the top of
12V harness connector
(MQUSM)
page 6 or illustration at right. Connect the
female and male 12V power connectors
first then route the type-c connector to
the designated slot created during the
::r�--=•
Male Connector to
preparation step at the bottom of page 6.
Back of 12V Socket
9. With the power connected to the
I-harness, route the type-c connector
under the shifter panel and through the
hole created in the preparation step on
page 5, and lastly through the HAQ02 Qi
bezel. Note: Tuck away any excess cable
under shifter panel, away from the shifter.
10.
Use the provided two-sided adhesives
to secure the panel/module from moving
then connect the Qi module to the type-c
connector. Once the module is connected@,..,.-....,.....,
place it into the bezel then reconnect
everything in reverse order of the
disassembly to complete the installation.
11.
Lastly, place your Qi enabled device onto
the HAQ02 assembly to charge your
device, see LED Charging Status on page
6 for more details
7
