Crown Liner Removal
6
5
Peak Visor Install
Occassionally the crown liner may require
removal for washing, replacement or to
change sizes.
First step is to remove the Cheek Pads.
(refer to page 4).
At the back of the helmet pull the crown
liner away from the shell.
Pull the crown liner out of the helmet while
gently detaching it from the forehead
channel.
Reverse this process for installation.
With the peak visor in the open position,
align the arrows located on the outer edge
of the peak visor and baseplate unit.
Firmly press down to secure the peak visor
to the baseplate. Perform this on both
sides of the helmet.
Once both sides of the peak visor are
snapped into place, move the peak to the
closed position. A locking screw is located
on the inside of the peak visor. To ensure
this screw sits to the inside of the
baseplate you will need to press the peak
visor in towards the helmet while closing.
Verify the peak is sitting flushed to the shell
when in the fully closed position. If the peak
visor is not sitting flush when closed then
re-open the peak and re-peat step 2.
1
2
3
PULL
Содержание Exo-CT220
Страница 1: ......
