Perimeter Sensor (SN-5)
Mounting the SN-5 Perimeter Sensor
The Perimeter Sensor uses high frequency microwave technology to detect mass density
movement around the motorcycle. The signal can transmit through the seat, fiberglass,
leather and plastic, but not metal. It is recommended to place this sensor under the seat
as close as possible to the center of the motorcycle. With the provided Velcro, you can
mount this sensor on top of the battery or any flat surface, making sure that the top side of
the sensor is facing upwards. To prevent false perimeter alerts, ensure the perimeter sensor
is at least 3-4 inches away from the MCM.
Adjusting the Perimeter Sensor
Although the perimeter sensor is pre-set from the factory, it may be necessary to adjust the
sensitivity to suit your specific application.
1.
Stand at least 10’ away from the motorcycle and arm the system.
2.
With the remote outside of RFID range, walk towards the motorcycle and try to lean
over the top of it. Once the sensor detects movement, the siren will begin to chirp
slowly. If you back away from the motorcycle, the siren will stop chirping. If you
continue to move closer to the motorcycle, the siren will start to chirp faster with 2
additional stages and then go into a full alarm trigger.
3.
Sensitivity can be adjusted by removing the plastic cap counter clockwise and tuning
the adjustment screw. To increase sensitivity, turn adjustment screw clockwise. To
decrease sensitivity, turn the adjustment screw counter clockwise.
4.
The Perimeter sensor has an internal tuning control, which has been set at the factory.
This tuning control should only be changed if the sensor can not be properly set as
described in #3 above, please call Aritronix technical support.
9
Standard Features
•
Ultra low power drain MCM
•
Built-in Analog Devices accelerometer
•
Remote sensor control
•
Battery safeguard with “sleep mode”
•
Violation display
•
Selectable auto/ manual arming / disarming
•
Flashes signal lights
•
Integrated 120 dB multi-tone siren
•
Remote panic feature
•
Soft chirp arming
•
Selectable Perimeter Sensor arming
•
Flash input for diagnostics and possible future upgrades
•
Programmable override code to disarm alarm
•
Built in back up battery
Optional Accessories
•
Ignition Disable
- Prevents the engine from being started when the system is
armed and the remote is not within RFID range.
•
Perimeter Sensor
- Three-Stage Perimeter Sensor
•
Factory Connector Kits
– OEM style connectors that simply plug into the
motorcycle’s factory wiring harness. Connector kits are available for select
motorcycle models.
2
Plastic Cap:
Remove to
adjust sensitivity
To Accessory Harness on
Main Control Module (MCM)
Note: Do not turn sensitivity above half way. Doing so may cause false alarms.
