DigiLink US, ECO DC Version
DIGUSDCECO
Issue
1
1
PREFACE
Important Installation Information
It is the purchasers’ responsibility to determine the suitability of this equipment and its derivatives for any given
application, Scope cannot give specific advice in this manual, as each use will require independent evaluation.
Scope has, wherever possible, employed extra safeguards or designed optional equipment to further monitor
the system’s performance. Certain system installations, operational requirements or budgets may, however,
limit the effectiveness of these safeguards. Again, the suitability of the system for any given application must
therefore be decided by the installer and their customer, relative to the application and risk.
Licence
This equipment is cleared for use within the USA under a license assigned to the exclusive importer, PIPS
Holdings Inc. License No. 950415906. Certain restrictions apply in respect of power output and antenna
installations.
Alternative frequencies are available by formal license application (Form 600) via the FCC. These will not be
subject to the same restrictions as the standard assigned license. You should obtain the FCC Rules and
Regulations, Title 47, Part 80 to End, including Parts 90 and 95, available from the US Gov. Printing Office,
GPO Bookstore, FCC Office or www.fcc.gov/oet/info/rules/
Important Safety Information
Scope products are designed to operate safely when installed and used according to general safety practices.
The following requirements should be observed at all times.
Do NOT subject this equipment to:
Mechanical shock
Excessive humidity or moisture
Extremes of temperature
Corrosive liquids
This equipment is designed for indoor use, unless expressly stated otherwise, and must not be used in
classified Hazardous Areas, including areas containing explosive or flammable vapors, unless express
authorization has been given in writing by the manufacturer. If in doubt, consult your local product dealer for
further information.
Do not obstruct any slots or openings in the product. These are provided for ventilation to ensure reliable
operation of the product and to protect it from overheating.
Only use a damp cloth for cleaning (not liquid or aerosol based cleaners), and ensure that any power is
removed from the unit prior to beginning the cleaning operation.
Removal of covers from the equipment must only be undertaken by authorized service personnel, who must
ensure that power is isolated prior to removal.
