ConneXions II V7 MAC Mains, Multi Port Version
CONV7MAC 05/98
Issue 1
9
Other Antennas
The range and performance of this equipment can be improved by the addition of more efficient
antennas*. These can be installed either inside or outside the building and are connected to the transmitter
with 50 OHM coaxial cable.
Glass mount antenna (UHFGM): for installation on the inside of a suitable window. This can boost range,
especially if it is required in one direction from the building.
The centre fed half wave di-pole, measuring approximately 12 inches from tip to tip, will provide excellent
all round local signalling. This can be mounted either inside or outside a building. Two versions are
available:
1) a light duty antenna suitable for sheltered environments/internal installation (LUHFDP).
2) a heavy duty stainless unit with optional mounting hardware for more arduous applications (UHFDP).
Other antennas, including co-linears, are available for external applications. Consult our Sales Department
for further details.
Pre-terminated coaxial feeder cables are available for 5, 10 or 15 metre requirements.
Note !
High frequencies can equate to high power losses. Always use quality cable. RG58 is only
acceptable on cable runs of up to 5 metres. We recommend RG213, or equivalent, on greater lengths. If in
doubt consult our Technical Department.
*subject to license conditions. Specifically, mounting height and Effective Radiated Power (ERP)
.
Service Information
If you experience a problem with your equipment you must first telephone our service hotline, where we
may request that you undertake a few simple checks. If a problem still remains, we will arrange collection
of your system by overnight carrier at our expense. Upon receipt, we will endeavour to service or replace
the system within 24 working hours and return the same by overnight carrier.
We suggest that you retain the packaging for your control equipment. Incorrectly packed goods returned
for service are the responsibility of the customer. If we deem that new packaging is required before we can
return the unit, a charge will be made.
In the event that a pager requires service, return it directly to Scope in the pre-addressed service bag
supplied with your system by registered post. Ensure that you carefully fill out the service form provided.
Failure to complete this form in full will result in inevitable delays!
Pagers returned with flat, incorrectly installed or leaking batteries will be charged for!
Record your system details here for quick reference:-
Date supplied____/____/____ Serial Number of the base console_________
Transmitter frequency ________MHz Transmitter RA Type approval 13249 CONX7AC
Number of pagers supplied with the system _______
System base ID number________________
Transmitter baud rate ______________
Serial input baud rate_____________
For information on individual pager types, refer to the appropriate pager manual
For information on use with the telephone I/F, refer to the separate Telephone Interface manual.
