Refrigeration
Refrigeration
Freezer
Installation Guidelines
When installing this freezer, ensure the installation guidelines below are considered and met
.
Ventilation Requirements
This freezer must have the following ventilation clearances at all times. In certain climatic conditions, condensation may
form on the back of the cabinet. If this is observed, ensure air circulation between cabinet and wall by adhering two of the
enclosed self-adhesive blocks to the cabinet back as shown.
Ventilation
Ensure all ventilation
requirements below are
met.
Door Opening
Allow adequate space for
the door/s to open and
close properly.
Sunlight
Do not install the freezer
in direct sunlight.
Uneven Surface
Do not install the freezer
on an uneven surface.
Surface
The installation surface
must be capable of
supporting the loaded
cabinet.
Power Supply
Do not overload the power
supply.
Blocking Ventilation
Do not store boxes or items in
front or on top of the freezer.
Climate Class
The freezer must be
installed in an environment
within its climate class.*
The climate class is stated
on the cabinet rating label
inside the freezer, and
specified on the back page
of this user guide.
No below clearance required
Min.
300 mm
above*
No behind
clearance
required
Vented top sign*
Min.
300 mm
above*
No side
clearance
required
Rear top sign*
50mm
Adhesive Blocks
If required use two adhesive blocks on the rear of the cabinet. Position
the blocks on the left and right hand sides of the cabinet, approximately
in the centre and 50 mm from the cabinet edge
.
