Before commencing with programming ensure the blind, window etc. is
fully open. This can be done by briefly pressing the PROG button on/off
controlling each direction and off.
Press & hold the ‘programming’ button on the receiver for 2 seconds
(the status LED will flash with a 1 second interval).
Programming Button
Status LED Will
Flash Once Per
Second
To assign the chosen transmitter button, press the down button ONCE
for DOWN.
With pairing the DOWN button, the UP button will automatically be
programmed opposite.
Function Button
To exit programming mode press the ‘programming’ button for
less than 1 second.
Press And Hold
2 Seconds
Press The Button Once
Press And Hold
For <1 Second
Press And
Hold For 5
Seconds
Status LED Will Flash
Twice Per Second
Function Button
Press The Transmitter Button
That Corresponds To The
Desired Function To Remove
STAGE 1
STAGE 2
STEP 1 - Programming Mode
STEP 2 - Pairing The Transmitter
Straight after ‘Step 2’, whilst still in programming mode, the time
settings for up and down (open and close) can be programmed.
3A
- To set the time element, with the LED already flashing once a
second press & hold the ‘programming’ button for 5 seconds (the
status LED will flash twice in a 1 second interval).
3B
- Press and hold the DOWN button to completely close the blind.
3C
- Press and hold the UP button to completely open the blind.
The operation time is now set.
Status LED Will Flash
Twice Per Second
STEP 3 - Adjust The Timings
STEP 4 - Save & Exit
To Remove A Single Function
To Remove All Stored Functions
Each time the transmitter button is pressed the LED on the receiver will
also flash to confirm the signal has been received.
Press And Hold
For 5 Seconds
Press and hold the ‘programming’ button for 8 seconds.
The LED will flash once per second after 2 seconds,
then twice per second after 5 seconds then go back
to once per second, the functions are now removed.
Press the programme button for <1 second to exit
programming mode.
When installing with the RF Pilot or RF Touch, use the dedicated product manuals for programming.
4
Programming The Receiver To Button Transmitters
Scolmore Park, Landsberg, Lichfield Road Industrial Estate, Tamworth, Staffordshire B79 7XB
Tel: +44 (0) 1827 63454 Fax: +44 (0) 1827 63362
www.scolmore.com
V2.0
5
Control
When controlling the shutter/blind receiver using the programmed transmitter,
short presses will move the shutter/blind in small increments.
Press and hold for longer than 2 seconds will allow the shutter/blind to fully open
or close until it reaches the limit switch.
On the Smart Box, RF Pilot and RF Touch, the open and closing times can be
entered directly in to both devices.