SCM Smith-Corona Zephyr Deluxe, Руководство пользователя

Страница: 5 / 6

REPLACING RIBBONS
Ribbons come wound on proper spools to fit
When purchasing replacement ribbons be sure
to specify the “Zephyr? and give ule
serial number of your machine,
Move the carriage to the extreme Icft, and
remove the cover plate. Wind all the ribbon
onto one spool, using the Manual Ribbon
Reverse Lever if necessary. Hold the ribbon on
both sides of the ribbon vibrator, sliding the
ribbon down and then up and out of the vibrator.
Pull up on each of the ribbon spools, and remove
both spools.
Unfasten the ribbon from the empty spool by
carefully pulling off the metal clip holding the
ribbon on the spool. Keep the empty spool and
the metal clip; discard the old ribbon on its
spool.
Set the Manual Ribbon Reverse Lever in the
right position. Unwind about 12 inches of the
new ribbon, and put the new spool and ribbon
into the right ribbon cup, making certain the
spool is seated on the spindle. Be sure the ribbon
winds from the back of the spool.
Lay the loose end of the new ribbon on the
hub inside the empty spool. Snap the metal
clip over the ribbon to fasten it. Wind enough
ribbon on the empty spool to cover the metal
eyelet in the ribbon. Set the Manual Ribbon
Reverse Lever in the left position, and put the
spool into the left ribbon cup. Make sure the
ribbon winds to and from the back of each
spool.
Slip the ribbon into the slots of the ribbon
guides adjacent to the left and right ribbon
spools cups.
Lock the Shift Key in the capital-letter pusition.
Slip the ribbon between the Line Indicator and
the ribbon vibrator. (See figure 1 below), Hold
the on both sides of the vibrator,
the lower cdge of the ribbon into the
tower part of the vibrator, (Sce figure 2). Slide
the ribbon from side to side, straightening it so
it fits into the upper part of the vibrator. (See
figure 3). Pull the ribbon a little to the left
and right to make sure it is correctly threaded.
Take up slack by turning the ribbon spool.
Replace the cover plate, making certain it is
securely held in place by the rear retaining
springs.
1.
RIBBON VIBRATOR