7
6.2 Mode B
When the instrument is turned ON and values for speed
and time are erased to zero, users can set. The upper speed
limit that has been set is taken over from operating mode
A and cannot be modified. After the power has been turned
OFF, the instrument will no longer automatically start up in
operating Mode B by itself.
After turning ON the instrument and selected run mode, the
following process will be shown on the display.
• The left LCD displays
“
SAF
”
and the right displays the
upper speed limit( rpm
）
which cannot be changed.
Figure 7
• The LCD displays run modes
“
StA
”
for about 2
seconds.
Figure 8
• The set speed value is shown in the left display, and the set
time value is shown in the right display. Then set the motor
rotary speed and time.
Figure 9
Figure 10
• After pressing the speed knob or time knob, the instrument
begins to run at the set speed. The actual speed and time
remaining are shown in the LCD. If the remaining has
reached zero, the shaker stops its motion.
Figure 11
Note:
The set values can be varied during shaking.
Shaking can be stopped by pressing the left or
right knob.
6.3 Switching the mode
Switch the operating mode as follows:
• Turn OFF the instrument with the mains switch.
• Hold down both knobs and turn ON the instrument with
