24
3.3.1 Control Racks
For connecting the PatchStar to the Control Rack and user interface please see the relevant
Control Rack User Manual.
4.0 Powering up the system
Once all positioning and cable connections are complete you are ready to switch on your
PatchStar system.
Power on the system using the on/off switch on the front of the 1U rack controller.
4.1 Operating the PatchStars
For operation of the PatchStar manipulators using a User Interface Controller, such as the
Control Cube or PatchPad Display, please see the relevant user manual.
For operation of the PatchStar manipulator using the LinLab software, as well as
configuration options available please see the LinLab user manual.
5.0 Maintenance
WARNING:
Do not tamper with any fixings other than those indicated in the
manual for mounting purposes.
There are no user serviceable parts within the PatchStar.
Do not use an inadequately rated mains power cable for the PatchStar Control
Rack other than those specified in this manual.
If the detachable mains cable is replaced care must be taken to ensure that a replacement
cable of adequate rating is used to ensure damage to the user or system does not occur.
Replacement cable provided must meet local electrical regulations and be sufficient for:
•
100-240volts
•
50-60Hz
•
5 amps
•
Fused- T1.6A L 250v
5.1 Cleaning
WARNING:
Switch off and disconnect the mains supply before cleaning the
unit. There is no integrated mains disconnect located within the PatchStar. Mains
power must be disconnected by switching off the mains power supply outlet and
disconnecting the mains power supply cable.
