10
SM5060-2 User Manual
Operating Instructions
General Information
The logical front panel layout of
ensures rapid familiarization with the
SM5060-2
various functions. However, even experienced operators should not neglect to
carefully read the following instructions, to avoid any operational errors and to be
fully acquainted with the instrument when later in use.
After unpacking the instrument, check for any mechanical damage or loose parts
inside.Should there be any transportation damage, inform the supplier
immediately and do not put the instrument into operation.
Safety
The case, chassis and all measuring parts are connected to the protective earth
contact of the inlet. The mains plug shall only be inserted in a socket outlet
provided with a protective earth contact. The protective action must not be negated
by the use of an extension cord without a protective conductor.
WARNING!
ANY INTERRUPTION OF THE PROTECTIVE CONDUCTOR INSIDE OR
OUTSIDE THE INSTRUMENT OR DISCONNECTION OF THE PROTECTIVE
EARTH TERMINAL IS LIKELY TO MAKE THE INSTRUMENT DANGEROUS.
INTENTIONAL INTERRUPTION IS PROHIBITED. THE MAINS/ LINE PLUG
SHOULD BE INSERTED BEFORE CONNECTIONS ARE MADE TO
MEASURING CIRCUITS
.
When removing the metal case or replacing, the instrument must be completely
disconnected from the mains supply. If any measurement or calibration
procedures are unavoidable on the opened-up instrument, these must only be
carried out by qualified personnel acquainted with the danger involved.
Operating Conditions
The ambient temperature range during operation should be b 0 to +40 C
0
0
RH 95% should not exceed -40 C or +70 C during transport or storage. The
0
0
operational position is optional, however, the ventilation holes on the
SM5060-2
must not be obstructed. Prior to calibration a preheat run of approx. 30 minutes is
required.
