© 2021 Pacific Cycle Inc.
4902 Hammersley Rd.
Madison, WI 53711
Remove the EXISTING handlebar grips
❶ Remove both existing grips (1a and 1b) by turning the
left grip clockwise, and the right grip counter-clockwise.
❷ Remove both washers (2a and 2b).
❸ Loosen the hex screw on the thumb lever and remove
the thumb lever.
❹ Loosen the hex screw on the hand brake and remove the
hand brake.
Attach the NEW handlebar grips
❶ Slide the new clamps (1a and 1b) onto each side of the
handlebar until it meets the center control panel.
❷ Route the wire into the clamp slot.
❸ Slide the thumb lever onto the right-hand grip until it meets
the clamp.
❹ Slide the hand brake onto the left-hand grip until it meets
the clamp.
❺ Insert the new grips (5a and 5b) completely through the
brake and clamps. Rotate the left grip clockwise and the
right grip counter-clockwise until fully tightened.
❻ Confirm the L and R sticker (6a and 6b) on the end of each
new grip matches the correct side.
❼ Tighten the hex screws (7a and 7b) on the clamps using the
4 mm hex key.
❽ Tighten the hex screw in the thumb levers using the 3 mm
hex key.
❾ Tighten the hex screw in the hand brake using the 5 mm
hex key.
Note: Discard the washers,
and existing grips, they are
no longer needed.
R
L
❸
❸
❽
❷
❹
❾
R
L
Thin side
faces in
Thick side
faces out
❹
❸
After
Before
1a
1a
2a
2b
1b
1b
5a
5b
6b
7b
7a
6a
