Page 7
620-8543 Rev. I
Install
16. On the Echelon2G console, press and hold
STAGE
and “AVG/MAX” for 3-5 seconds
to access the service menu.
17. Use AVG/MAX to scroll until SENSOR TYPE
is displayed then push the back-light button
to access the sensor menu. Ensure that
“4iiii” is displayed as the sensor type.
18. If the sensor type is set to “Echelon 2” press
the back-light button
to select the sensor
type, use the AVG/MAX button to select “4iiii”
then press the back-light button
again.
19. Once “4iiii” is selected the console will enter
the pairing process, check the side of the
power sensor for a 4 OR* 5-digit ANT+ ID
code. Enter this code on the “ENTER ANT
ID” screen using AVG/MAX to scroll and the
back-light
to enter the ANT+ ID.
20. Once the ANT+ ID has been entered, pedal
the bike, then select “PAIRING SPIN CRANK”
but pushing the back-light button
. If
pairing does not pass, check to ensure the
ANT+ ID is correct and try the pairing process
again. It may take 2-3 attempts to pair
successfully.
Please note that the ANT+ ID referenced in Step
4 could be either a 4-digit OR 5-digit number.
If the 4-digit code is present, the first number of
the ANT+ ID Code is zero (0).
21. After successfully pairing the 4iiii crank, the
power sensor must be calibrated BEFORE
riding the bike. Press and hold STAGE
and AVG/MAX for 3-5 seconds to access
the service menu then use AVG/MAX to
scroll until “CALIBRATE” is displayed
then select it using the back-light button
. “ZERO RESET” will be displayed,
press the back-light button
to select it.
Once “SPINCRANK” is displayed, spin the
crank and press the back-light button
to proceed. Ensure that the left crank arm
is in the 6 o’clock position then follow the
on-screen directions to finish calibrating the
sensor.
