Page 1
1.
Use a small phillips screwdriver to remove the
screw securing the battery cover, remove the
battery cover, then install the batteries. Once
the batteries are installed, replace the cover
and screw.
Fig. 1
2.
Ensure that the rider’s right crank arm is at
the 6 o’clock position then push the crank
onto the bottom bracket at the 12 o’clock
position. Finally, using a torque wrench with
an 8mm allen socket attached, torque the
crank bolt to 40-44 ft-lb (55-60 Nm).
Fig. 2
3.
Install the pedal into the crank arm then use
a torque wrench and a 8mm allen socket
to torque to the pedal bolt according to the
specifi cations below:
Threaded Pedal: 25-30 ft-lb (34-40 Nm)
Morse Taper Pedal: 33 -37 ft-lb (45-50 Nm)
NOTE:
The pedal MUST be torqued to the above
specifi cations otherwise a failure of the pedal may
occur.
Fig. 3