Schweitzer Engineering SEL-351P, Быстрый старт

Страница: 66 / 674

Settings
60 SEL-351P Quick-Start Installation and User's Guide (Portuguese)
Global EZ Settings
No. Setting Default Range Incr.
38 System Frequency 60 50, 60 Hz
Enter nominal System frequency .
No. Setting Default Range Incr.
39 Phase Rotation ABC ABC, ACB
Enter system Phase rotation .
No. Setting Default Range Incr.
40 Recloser Wear Monitor AUTO AUTO, Y, N
Recloser Wear Monitor = Y:
The recloser wear monitor must be set at a higher level, with the SET G command (see the SEL-351P
Manual Técnico ). This setting is usually selected if a circuit breaker is connected to the SEL-351P
instead of a GVR recloser.
Recloser Wear Monitor = N:
The recloser wear monitor is turned off.
Recloser Wear Monitor = AUTO:
This setting is usually selected if a GVR recloser is connected to the SEL-351P. Enter the following
setting:
Setting Default Range Incr.
Interrupt rating 6000 6000, 8000, 12000 Amps primary 1
These settings are derived from Whipp & Bourne Switchgear: Installation, Operation, and
Maintenance Manual, GVR Auto-Recloser, Issue C, July 1996, section 5.2.2 Vacuum Interrupters.
Make these settings by finding your recloser model in Table 10 and then entering the corresponding
settings.
•
This setting is hidden and nonoperative if Recloser Wear Monitor
≠
AUTO.
Table 10: Recloser Interrupt Data
Recloser Model Interrupt Rating (Amps primary)
GVR (15 kV, 6kA) 6000
GVR (15 kV, 12 kA) 12000
GVR (27 kV, 12 kA) 12000
GVR (38 kV, 8 kA) 8000