LWH 031 031 / LWH 032 031
Concrete/Brick Installation
SCHWAIGER GmbH, Würzburger Str. 17, 90571 Langenzenn
Tel H49 (0)9101 702 299
www.schwaiger.de
Note: 1/4”(8mm) anchor must be used for
concrete installation. They can be purchased at
your local hardware store.
1. Place the wall plate against the wall with the hook
towards the bottom.
2 .Level and mark with a pencil the two mounting
points found on the wall plate.
3. Next, drill two holes using an electric drill and
1/4” masonry bit
4. Insert the threshold anchors into the holes that
were drilled in the wall.
Note: If necessary, use a hammer to lightly tap
each anchor into place so that they are flush with
the wall.
5. Once the anchors are in place, put the wall piece
back over the concrete anchors.
6. Using a screw driver, attach the back plate by
threading the two screws into the anchor which has
been recessed into the wall.
7. Make sure all screws are snug, but be careful not
to over-tighten them.
Step 2 – Attaching the Arm to the LCD
1. Determine the mounting hardware that is to be
used.
2 If your LCD has a flat back, use the M4x12mm
Philips Head Screws (B).
Note: If your LCD has a recessed back, use the
longer M4x30mm Phillips Head Screws (C) and
3/4” spacers (D).
3. After you have determined the appropriate screws,
use them to attach the mounting plate to the back of
your LCD
4. Do not over-tighten the screws.
Step 3 – Final Installation and Operation
Final Installation
1. To complete the installation, simply slide the
arm piece onto the wall plate.
2. The plastic tab on the top of the wall piece
should click, indicating that the arm piece is secure.
3. If you need to remove the arm piece, push in on
the tab and slide the arm up.
4. For additional security and stability, tighten the
security bolt located on base of the arm piece
using the Allen Wrench (F) included in the
hardware kit.
Operation and Adjustment
NOTE: Adjustment of your LCD may vary by
model.
On most models, the tilt angle of your LCD can be
adjusted by first loosening the gear joint that holds
the tilt in place. To do this, locate the adjustment
knob directly behind the LCD mounting point.
Loosen it by turning the knob counter-clockwise.
Adjust the tilt to the desired level and re-tighten
the knob.
Other viewing adjustments can be made by simple
moving the arm into the desired position. If you
find that a joint is too difficult to move or does not
hold the LCD in place, you can adjust the tightness
of the joint. If your mount includes black adjustment knobs, turn a knob clockwise
to tighten and counter-clockwise to loosen. If your mount does not have knobs, use
the Allen Wrench (F) to tighten or loosen the joint.
