LWH 031 031 / LWH 032 031
GB
LCD MOUNT INSTALLATION INSTRUCTIONS
This mount is designed for secure installation of LCD displays up to 40lbs.(18kgs) in weight.
SCHWAIGER GmbH, Würzburger Str. 17, 90571 Langenzenn
Tel H49 (0)9101 702 299
www.schwaiger.de
Warning Statements
The wa
Warning
ll structure must be capable of supporting at least a maximum
weight of 40lbs(18kgs). If not, the wall must be reinforced. Proper
installation procedure by a qualified service technician, as outlined in
the installation instructions, must be adhered to. Failure to do so
could result in serious personal injury, or even death.
Warning
Safety measures must be practiced at all times during the installation
of this product. Use proper safety gear and tools for the installation
procedure to prevent personal injury.
Warning
Prior to the installation of this product, the installation instructions
should be read and completely understood. The installation
instructions must be read to prevent personal injury and property
damage. Keep these installation instructions in an easily accessible
location for future reference.
A secure structure must support the weight or load of the display,
When mounting to a wall that contains wooden studs, dead center of
the wooden stud must be confirmed prior to installation.
Do not install on a structure that is prone to vibration, movement or
chance of impact. Failure to do so could result in damage to the
display and/or damage to the mounting surface.
Do not install near heater, fireplace, direct sunlight, air conditioning
or any other source of direct heat energy. Failure to do so may result
in damage to the display and could increase the risk of fire.
At least two qualified people should perform the installation
procedure. Injury and/or damage can result from dropping or
mishandling the display.
Recommended mounting surfaces: wooden studs and solid-flat
concrete. If the mount is to be installed on any surface other than
wooden studs, use suitable hardware (which is commercially
available).
Hardware kit:
x2pcs 2” Wood Screw
(A)
x4pcs 3/4” Spacer
(D)
x4pcs M4x12mm
Philips Head Screw
(B)
x1pc Bubble Level
System (E)
x4pcs M4x30mm
Philips Head Screw
(C)
x1pc S=5mm Allen
Wrench (F)
Tools Required:
Phillips Head Screw driver
Stud finder for drywall installation
Electric drill and 1/4” (8mm) masonry bit for concrete/brick installation
Note: You need to insert the bubble level system when you install the wall plate
and take it away fate you finish installation.
Step 1 – Mounting the Wall Plate
Wood Stud Installation
Note: Using a wood stud finder, locate the stud
centers behind the wall. Once found, make a
pencil marking on the center of the wood studs.
Once the mark is made, it is strongly
recommended that a pilot hole be drilled with a
1/8” drill bit.
1. Place the wall plate against the wall with the
hook towards the bottom.
2. Secure the wall plate using one 2” wood screw
(A).
3. Using the bubble level system (E), carefully
adjust the wall plate until it is level.
4. Attach the remaining 2” wood screw into the
wall plate and tighten.
