MANUFACTURER INFORMATION
Dear Customer,
should you require technical advice and
your retailer could not help please contact
our technical support.
Schwaiger GmbH
Würzburger Straße 17
90579 Langenzenn
Hotline: +49 (0) 9101 702-199
www.schwaiger.de
Swivel bracket
Connector for
loosening/
installation
Mounting plate
Logging in (inclusion) or logging out (exclusion) of the sensor
By pressing the black switch at the right side (I) for one second you
confirm the inclusion and exclusion of the device.
USER MANUAL ZHS05
Congratulations and thank you for purchasing the Schwaiger
ZHS05 product. Below you will find useful operating guidelines.
MULTISENSOR
ZHS05
BDA_ZHS05_e
Mounting plate
Product description
The multi-sensor is powered by batteries or USB. It consists of a motion, temper-
ature, humidity and light sensor. The sensor sends signals to up to 6 associated
Z-Wave devices in its own network, if it finds movements in the observed area. The
multi-sensor meets the protection class IP43 and is therefore suitable for outdoor
use. Through different settings of the sensitivity the detection of small animals
such as dogs and cats can be prevented. The multi-sensor is supplied with a swivel
bracket for wall mounting and a mounting plate for ceiling mounting.
Batteries
This device is powered by batteries. Use only bat-
teries of the specified type. Never mix old and
new batteries in the same device. Used batteries
contain hazardous substances and must not be
disposed of with household waste! Battery type:
4 x AAA
Installation guidelines
1.
Loosen the multi-sensor from the battery
holder by turning it counter clockwise
(symbol: „lock“/“unlock“).
2.
Insert 4 AAA batteries into the battery holder.
(not included)
3.
The sensor can be installed as follows on the wall
or ceiling:
(a)
For installation on the wall, attach
the swivel bracket with screws to the wall.
Then install the sensor together with the
mounting plate to the bracket.
(b)
For installation on the ceiling attach
the mounting plate by means of the screws to
the ceiling.
4.
Attach the multi-sensor to the bracket by again
turning it clockwise to the „lock“ symbol.
Be sure to face the temperature/humidity sensor down when
mounting it outside to protect it from rain and snow.
1,5V - AAA
LR 03
1,5V - AAA
LR 03
1,5V - AAA
LR 03
1,5V - AAA
LR 03
1
3 (a)
3 (b)
2
I
