SCHUNK VERO-S NSE-T3 138, Сборка и руководство по эксплуатации

Страница: 50 / 60

Troubleshooting
50 03.00|1152197 NSE3, NSE-T3 |en
Troubleshooting
The clamping area does not unlock
Possible cause Remedial measures
Defective air connections Check air supply
Pressure below minimum Check operating pressure (min. 5 bar)
A component is broken (e.g. due to
overloading) Replace the module or send it to SCHUNK for
repair
Excess tensile load on clamping pins Reduce support weight
The clamping area does not unlock properly
Possible cause Remedial measures
Pressure below minimum Check operating pressure (min. 5 bar)
The module was not operated with oiled
compressed air Install maintenance unit with oiler
Hose diameter below minimum Required hose diameters, see chapter
"Securing and connecting"
(

4.3, Page 23)
The turbo connection is still pressurized Ventilate the connection
The quick-change pallet system no longer opens quietly
Possible cause Remedial measures
The clamping faces on the clamping slides
and on the clamping pin are dirty Remove the clamping pin and clean the
clamping faces on the clamping slides and on
the clamping pin
If the clamping area does not unlock properly
Possible cause Remedial measures
Clamping pallet is not flat Depressurize media transfer units, bleed
supply to transfer units
Clamping pallet is not flat Increase the force applied to the coupling
connection until the flat contact surface of the
module has been reached
Clamping pallet is not flat Check installation position of coupling
elements
8
8.1
8.2
8.3
8.4