SCHUNK SWS-001, Инструкция по установке и эксплуатации

Страница: 29 / 40

Maintenance
01.00|SWS-001 |en 29
Cleaning and Lubrication of the Locking Mechanism
Clean Outer and Inner Surfaces of Alignment Locking posts on the Tool Plate
1 The locking mechanism must be in the Unlock state before
cleaning.
2 Use a clean rag to thoroughly remove the existing lubricant
and debris from the outer surface of the alignment locking
posts on the SWA. Clean the inner surfaces and ball sockets of
the alignment locking posts by pushing the rag through in the
narrow passages with a small shaft.
Clean Inner Surface and Alignment Pins of the Master Plate
3 Clean the inner surfaces, balls, and alignment pins of the SWK
by pushing the rag into the narrow socket with a small shaft.
Apply Lubricant to the Alignment Locking Posts on the Tool Plate
4 Apply a moderate coating of lubricant to the alignment locking
posts inside and out.
8.2