SCHUNK SPG 100, Сборка и руководство по эксплуатации

Страница: 27 / 32

Maintenance and Care
01.02|SPG 100|en 27
Servicing and assembling the module
• Clean all parts thoroughly and check for damage and wear.
• Treat all greased areas with lubricant.
(

9.3, Page 25)
• Oil or grease bare external steel parts.
• Replace all wear parts / seals.
– Position of the wearing parts
(

10, Page 28)
– Seal kit
(

11, Page 29)
Assembly takes place in the opposite order to disassembly.
Observe the following:
• Unless otherwise specified, secure all screws and nuts with
Loctite no. 243 and tighten with the appropriate tightening
torque.
(

9.5.1, Page 27)
Screw tightening torques
Position of the position numbers
(

10, Page 28)
Screw tightening torques
Item SPG 100
30 45 Nm
32 20 Nm
33 25,5 Nm
34 25,5 Nm
9.5
Maintenance
Assembly
9.5.1
www.comoso.com