Assembly
36
04.00|0889132_ROTA TB2 / ROTA TB2 LH |en
Assembly
Pre-assembly measures
Carefully lift the product (e.g. using suitable lifting gear) from the
packaging.
CAUTION
Danger of injury due to sharp edges and rough or slippery
surfaces
Use personal protective gear, especially safety gloves.
Check the delivery for completeness and for transport damage.
Check the machine spindle head or machined intermediate flange
for radial and axial runout. The maximum permissible value is
0.005 mm according to DIN 6386 and ISO 3089 .
The bore holes on the locating face must be chamfered and the
face must be completely clean.
CAUTION
Excessively long fastening screws can stand up in the tapping
drill hole or damage the machine spindle.
During assembly of the chuck and flange the length of the
mounting screws must be taken into account.
In case of optional mechanical pressure monitor with inductive
proximity switch:
Loosen set screw (107) and remove switch cam (93).
For mechanical stroke monitoring with inductive proximity
switches:
Disassemble switch cam (92) (in case of dual stroke chuck).
5
5.1
