SCHUNK PZH-plus, Сборка и руководство по эксплуатации

Страница: 39 / 48

Maintenance
7.5 Servicing and assembling the module
Position of the item numbers } 7.6 [
/
39]
Maintenance • Clean all parts thoroughly and check for damage and wear.
• Treat all greased areas with lubricant.
}
7.3 [
/
35]
• Oil or grease bare external steel parts.
• Replace all wear parts / seals.
– Position of the wearing parts } 7.6 [
/
39]
– Seal kit } 1.4.1 [
/
7]
Assembly Assembly takes place in the opposite order to disassembly.
Observe the following:
• Unless otherwise specified, secure all screws and nuts with
Loctite no. 243 and tighten with the appropriate tightening
torque.
}
7.5.1 [
/
39]
7.5.1 Screw tightening torques
Position of the item numbers
}
7.6 [
/
39]
Values in Nm
Item 42 46 47 48 54 56
20 0.8 1.3 0.8 0.8 1.3 1.3
30 1.3 6.0 1.3 1.3 6.0 6.0
50 10.0 6.0 6.0 1.3 10.0 6.0
75 25.0 48.0 25.0 1.3 48.0 10.0
7.6 Assembly drawing
The following figure is an example image.
It serves for illustration and assignment of the spare parts.
Variations are possible depending on size and variant.
39 06.00 | PZH-plus | Assembly and Operating Manual | en | 389504