SCHUNK LGP 08 - 40, Сборка и руководство по эксплуатации

Страница: 20 / 24

Troubleshooting
20 03.01|LGP 08 - 40|en
Troubleshooting
Modul does not move?
Possible cause Corrective action
Base jaws jam in housing, possible cause:
bolting surface not sufficiently level. Check the levelness of the bolting surface.
(

7.1, Page 13)
Loosen the mounting screws for the gripper
and actuate the gripper again.
Pressure drops below minimum. Check the air supply.
(

7.2, Page 14)
Compressed air lines switched Check compressed air lines.
Proximity switch defective or set incorrect. Repair the proximity switch.
Unused air connections not closed.
Close the unused air connections.
Choke valve closed. Open the choke valve.
Component is broken, e.g. through over-
loading Replace the module.
The module does not travel through the entire stroke?
Possible cause Corrective action
Pressure drops below minimum. Check the air supply.
(

7.2, Page 14)
Mounting surface is not even enough Check the levelness of the bolting surface.
(

7.1, Page 13)
Component is broken, e.g. through over-
loading Replace the module.
Module opens or closes abruptly?
Possible cause Corrective action
Compressed air lines are blocked Check the compressed air lines for crushing
or damage.
Mounting surface is not even enough Check the levelness of the bolting surface.
Throttle check valve is missing or not set
correctly Install and adjust throttle check valve
Load too high Review permissible weight and length of the
jaws
(

7.1, Page 13)
8
8.1
8.2
8.3