_________________________________________________________________________________________
schunk.com
XND.00022.002_B – 10/2018
22
4.3
Jaw change
The system jaws are attached on the carriages using two M10 cylinder screws each. When
changing the jaws or moving them in the carriages, these screws have to be tightened using a
torque of
50 Nm.
4.4
Clamping range
L-130
The adjustment distance of the clamping opening via the
spindle is max. 59 mm.
L-190
Each of the carriages is fitted with two mounting
positions for the system jaws.
The adjustment distance of the clamping opening via the
spindle is max. 70 mm.
Depending on the size of the workpiece,
the system jaws should be fitted into the most suitable
carriage slots.
For further data, please see the current catalogue >> Schunk stationary Workholding <<
Important
:
Before clamping the workpiece, the M10 fixing screws from the system jaws must be
tightened with a torque of 50 Nm..
Failure to comply with this rule can result in insufficient workpiece clamping
and hence to loss of workpieces and damage.
