SCHUNK KGG 100-40, Сборка и руководство по эксплуатации

Страница: 34 / 44

Maintenance
34
15.00 | KGG 60-20 ... 140-60 | Assembly and Operating Manual | en | 389166
7 Maintenance
7.1 Notes
Original spare parts
Use only original spare parts of SCHUNK when replacing spare and
wear parts.
7.2 Maintenance intervals
NOTICE
Material damage due to hardening lubricants!
Lubricants harden more quickly at temperatures above 60°C,
leading to possible product damage.
•
Reduce the lubricant intervals accordingly.
Interval
(million cycles)
Maintenance work
2 Treat all grease areas with lubricant,
Lubricants/Lubrication points [
}
34]
2 Clean all parts thoroughly, check for damage
and wear, if necessary replace seals,
Drawings
[ } 37]
7.3 Lubricants/Lubrication points
SCHUNK recommends the lubricants listed.
During maintenance, treat all greased areas with lubricant. Thinly
apply lubricant with a lint-free cloth.
Lubricant point Lubricant
Metallic sliding surfaces microGLEIT GP 360
All seals Renolit HLT 2
Bore hole at the piston Renolit HLT 2