SCHUNK HGN 100, Сборка и руководство по эксплуатации

Страница: 26 / 36

Maintenance and Care
26 01.00|HGN |en
WARNING
Risk of injury due to spring forces!
The lid is under spring tension.
Carefully disassemble the module.
WARNING
Risk of injury due to spring forces!
The cylinder piston is under spring tension.
Carefully disassemble the module.
1 Remove oil feedings.
2 Remove the cover sheet plate (5).
3 Mark the installation position of the base jaws (2) and of the
pistons (3) inside the housing (1).
4 Remove the helical spring device (32).
5
WARNING! In case of a dammage the components may be
spring-packaged! Therefore clamp in the gripper before un-
tightening the screws between »a« and »b«. Then carefully
unclamp, until the spring has lost its power.
6 Remove the socket head cap screw (34).
7
WARNING! The components are spring-packed! Therefore
clamp in the gripper before untightening the screw between
»a« and »b«. Then carefully unclamp, until the spring has
lost its power.
8 Remove the spring guidance (31) and the spring (33).
9 Remove the cover (item 30).
10 Take out the the cylinder piston (item 6).
11 Draw out the base jaws (item 2) from the guidances and press
out the piston (item 3).
The seals (14 and 15) have to be assembled on mounting devices
(

9.6, Page 29) ,