• 4
•
ASSEMBLY INSTRUCTIONS
It is important to fully assemble your charger before use. Remove all cord wraps and
uncoil the cables prior to using the battery charger. Follow these instructions for assembly.
PARTS
TOOLS NEEDED
(2) 10-32 thread cutting screws
(2) 10-24 x 5/8" thread cutting screws
(4) 8-32 x 1" pan head screws
(2) wheels
(1) axle
(2) axle caps
(2) axle brackets
(1) handle
(1) foot
3/8" wrench (for mounting foot)
5/16" wrench (for mounting wheels)
1/4" wrench (for mounting handle)
hammer
flat-head screwdriver
Phillips-head screwdriver
1. Attach the foot:
Remove the
charger from the
packing materials
and place upside
down on a flat
surface. Attach
the foot and
secure it with the two 10-24 x 5/8" thread
cutting screws provided.
2. Assemble the wheels and axle:
Hold
the axle upright on the floor or work
surface. Then, using a hammer, tap
one of the axle caps onto the top end of
the axle. Be sure to tap the axle cap on
straight. Slide both wheels onto the axle
with the recessed hubs facing out as
shown. Install the second axle cap.
3. Mount the axle to the charger:
Place
one end of each bracket into the slot on
the bottom of the charger. Place the axle
assembly under each bracket. Attach
the brackets, using the two 10-32 thread
cutting screws provided.
NOTE:
Be careful not to drop the
brackets inside of the charger case.
4. Attach the handle:
Turn the charger right
side up onto its foot and wheels. Align the
handle, so the screw holes are aligned
with the screw
holes on each
side of the
charger. Attach
the handle,
using the four
8-32 x 1" pan
head screws
provided.
1
2
3
4
5
6
1
2
3
4
5
6
1
2
3
4
5
6
1
2
3
4
5
6
1
2
3
4
5
6
1
2
3
4
5
6
