•
3
•
RISK OF CONTACT WITH BATTERY ACID. BATTERY ACID IS A
HIGHLY CORROSIVE SULFURIC ACID.
2.6
Be sure the area around the battery is well ventilated while the battery is being charged.
2.7
Read, understand and follow all instructions for the charger, battery, vehicle and any
equipment used near the battery and charger. Study all of the battery manufacturer’s
specific precautions while charging and recommended rates of charge.
2.8
If battery acid contacts your skin or clothing, immediately wash the area with soap and
water. If acid enters your eye, immediately flood the eye with cold running water for at
least 10 minutes and get medical attention right away.
2.9
If battery acid is accidentally swallowed, drink milk, the whites of eggs or water. DO NOT
induce vomiting. Seek medical attention immediately.
3. BATTERY CHARGING – AC CONNECTIONS
RISK OF ELECTRIC SHOCK OR FIRE.
3.1
This battery charger is for use on a nominal 120-volt circuit. The plug must be plugged into
an outlet that is properly installed and grounded in accordance with all local codes and
ordinances. The plug pins must fit the receptacle (outlet).
NOTE:
Pursuant to Canadian
Regulations, use of an adapter plug is not allowed in Canada. Use of an adapter plug in
the United States is not recommended and should not be used.
3.2
An extension cord should not be used unless absolutely necessary. Use of an improper
extension cord could result in a risk of fire and electric shock. If an extension cord must be
used, make sure:
•
That the pins on the plug of the extension cord are the same size and shape as those of
the plug on the charger.
•
That the extension cord is properly wired and in good electrical condition.
• That the wire size is large enough for the AC ampere rating of the charger as specified below.
3.3
Recommended minimum AWG size for extension cord:
• 100 feet (30.5 meters) long or less – use an 18 gauge (0.82 mm
2
) extension cord.
• Over 100 feet (30.5 meters) long – use a 16 gauge (1.31 mm
2
) extension cord.
4. FEATURES
1
3
2
1.
LED Display
2.
Quick-Disconnect Cable
3.
XLR Connector Komex Assembly
5. ASSEMBLY INSTRUCTIONS
Remove all cord wraps and uncoil the cables prior to using the battery charger.
Содержание CR2
Страница 8: ... 8 ...
