5
1
0
1
0
/
9
0
0
0
5
9
1
1
8
8
*
5
9
1
1
8
8
*
Alignment
Intense noise formation, vibrations and “wandering” may be the result of incorrect
alignment.
Aligning the washing machine with a spirit level
1.
Loosen the lock nut using a wrench, by turning it in a clockwise direction.
2.
Change the height by turning the appliance feet.
Caution:
all four appliance feet must be firmly on the ground.
The washing machine must not wobble.
Check the alignment of the washing machine with a spirit level and adjust
if necessary.
3.
Tighten the lock nut against the housing.
In doing so, hold the foot tight and do not adjust its height.
Caution:
the lock nuts on all four appliance feet must be screwed tightly
against the housing.
Electrical connection
ʑ
The washing machine must only be connected to an alternating current via a
properly installed earthed socket.
ʑ
The power supply and voltage indicated on the washing machine (rating plate)
must be the same.
ʑ
The connected load and fuse required are specified on the rating plate.
ʑ
Make sure that:
– the mains plug fits the socket,
– the cable cross-section is adequate,
– the earthing system is properly installed.
ʑ
(If this is necessary), the mains cable may only be replaced by a qualified
electrician.
Replacement mains cables are available from the after-sales service.
ʑ
Do not use multiple plugs/couplings or extension cables.
ʑ
If a residual current circuit breaker is used, only use a type which displays this
symbol:
‚
.
Only this symbol guarantees compliance with the currently applicable regulations.
ʑ
Do not plug in or unplug the mains plug with wet hands.
Pull the appliance plug out of the socket at the plug only, not by the cable.
6
Transportation, e.g. when moving home
Before transporting the washing machine:
1.
Turn off the tap.
2.
Release the water pressure in the inlet hose
a
Operating instructions;
Maintenance - filter
in water inlet.
3.
Drain residual water
a
Operating instructions;
Maintenance - drain pump.
4.
Disconnect the washing machine from the power supply.
5.
Dismantle the hoses.
Preparing and installing transport braces:
1.
Remove the covers.
2.
Insert all 4 transportation protection devices and clamp the mains cable
to the holders. Tighten the bolts.
After transportation, the transport braces
must
be removed
a
page
3
.
To prevent unused detergent from flowing straight into the drain during the next wash: Pour
1 litre of water into compartment II and start the
<
Drain
programme.
Technical specifications
ʑ
Dimensions (width x depth x height)
60 x 59 x 84.2 cm
ʑ
Weight
72 kg
ʑ
Mains connection
Nominal voltage 220-240 V, 50 Hz
Nominal current 10 A
Nominal power 2300 W
ʑ
Water pressure
100
ä
1000 kPa (1
ä
10 bar)
ʑ
Test programmes
According to currently valid IEC 60 456
1.
2.
ʑ
a
ʑ
ʑ
ʑ
>
ʑ
ʑ
ʋ
ʋ
ʋ
ʋ
ʋ
ʋ
ʋ
ʋ
ʋ
ʋ
ʋ
ʋ
ʋ
