47
1.
Open the door.
2.
Press the button to release the maintenance flap.
3.
Open the maintenance flap all the way.
4.
Turn the two lock levers towards each other in the
direction of the arrow.
5.
Pull out the air cooler.
6.
Clean the air cooler element thoroughly, allow to drain well.
7.
Replace the air cooler. The handle must be at the
bottom. Turn the lock levers back again to lock.
8.
Push the maintenance flap closed on the left and right
sides at the same time (see diagram) until the lock
engages.
The door can only be closed if the maintenance flap is
closed properly!
Cleaning the moisture sensor
After long periods of operation, fine deposits (limescale,
fabric softener) can form on the moisture sensors on the
vanes and inside of the drum.
On electronic programmes, this can result in the desired
level of dryness not being reached. Wipe deposits away
with a cloth soaked in vinegar.
Emptying the machine for frost protection or transport
If the machine is in a room susceptible to frost or is to be
transported, it must be completely emptied.
1.
Empty the condensed water container (page 46).
2.
Select any drying programme.
3.
Press the start button. Any condensed water remaining
in the machine will then be pumped into the container.
4.
Stop the programme after around 5 minutes using the
fast forward button and empty the condensed water
container again.
Basic Settings
The machine has basic settings from the factory. It can be
adapted to the user's individual needs either when first
used or later using the following functions.
The basic settings can only be changed if no dry program-
me is. To change a basic setting, it is first necessary to
hold the programme button(s) pressed and then press the
fast forward button. The corresponding function is shown
on the display. The display changes when the fast forward
button is pressed repeatedly with the programme but-
ton(s) held down.
Example:
Function switched off
Function switched on
Initial dampness (ex factory
50%
)
Special programme «Easy dry» + «Fast forward»
The accuracy of the time remaining is increased if the
dryer is adjusted to the spin speed of your washing
machine.
Spin speed 1600 rpm - 50 % residual moisture
Spin speed 1200 rpm - 60 % residual moisture
Drying level (ex factory
NORMAL
)
«Time programme» + «Fast forward»
When this function is switched on, the level of dryness
for the electronic programmes (wardrobe and extra dry) is
slightly increased and the laundry will be slightly drier.
DRYING LEVEL
HIGHER
DRYING LEVEL
NORMAL
