9
7º- Raise the canopy to the ceiling to cover the ceiling-mount (ensuring the canopy rests on the two bracket screws), rotate the
canopy to ensure the screw headsalign with the holes on the bracket, and tighten the screws.
8º- Place the light shade on the underside of the fan body, covering the LEDring. Ensure the grooves on the shade diffuser align
with the pivots on the ring of the fan body, then turn the shade diffuser clockwise until it fixes in place.
4. Balance adjustment for this fan. "Invisible system"
Although the fans are balanced before shipping, balance can be affected by transit. As a consequence, re-balance the fan by
following these steps if you find that the fan has a noticeable wobbleonce fully assembled.
1º- Remove the balance kit from the packaging and place two of the balance magnets onany of the marked spaces, as shown in
Figure A. Then turn the fan on to see if it continues to wobble. Repeat this until you find the position that corrects the wobble and
allows the fan to run smoothly.
2º- Remove the balance magnets and attachthe balance kit in order to stick them in place. Figure B
TROUBLESHOOTING:
1. The fan won´t start.
-Check the fan wiring; ensure all the cables are connected correctly.
-Check and ensure that the input power is correct at 220V / 50HZ.
2. The fan makes a loud noise
- Ensure all the screws have been tightened correctly.
- Ensure the wire nut connections are not rubbing against each other or against the inside of the canopy box.
