Schrack Technik GENIO Dual Maxi Series, Руководство пользователя

Страница: 9 / 16

page
9
I
NSTALLATION
R
ACK VERSION
The sequence of operations required to convert the BATTERY BOX into the rack version is
described below.
WARNING: for your safety and that of your product, follow the information set out below
exactly.
BEFORE CARRYING OUT THE FOLLOWING SEQUENCE OF OPERATIONS, ENSURE
THAT THE BATTERY BOX IS NOT CONNECTED TO THE ELECTRICITY MAINS, TO
THE UPS OR TO ANY OTHER BATTERY BOXES
1 - First remove the 4 feet at the base of the
BATTERY BOX. Put the BATTERY
BOX into a horizontal position taking
the utmost care and with a small slotted
screwdriver carefully lift the pin at the
centre of the foot. Once it has been
lifted, remove the foot from the base.
Repeat the same operations for the
remaining feet. The exact sequence to
follow is shown at the side:
2 - Once all the feet have been removed, the mask must then be
rotated. Insert the keys provided in the release slots located at the
sides of the mask and exert enough gentle pressure to release it from the BATTERY
BOX, as shown in the figure at the side.
3 - (only for the version with battery charger) : The mask is connected to the BATTERY
BOX by a specific cable. The mask must therefore be removed with the utmost care
and avoiding violent pulls or other sharp movements so as to avoid any damage to the
LED panel and/or to the actual BATTERY BOX. DO NOT UNDER ANY
CIRCUMSTANCES TRY TO SEPARATE THE MASK FROM THE BATTERY
BOX.
4 - Rotate the mask 90° anticlockwise, carefully insert in the housing and exert gentle
pressure near the release slots until a slight click is heard with the mask remaining in
position.
1 2