
28
GB
Mounting
Mounting requires some technical
understanding.
Three people are required to mount the
awning.
You can do the actual mounting yourself,
but please be aware that the electrical
installation element must be carried out by
an authorised electrician, as the product is
delivered without a plug.
The awning should form an angle of about
80 degrees in relation to the wall when it is
extended. The mounting height (C) should
be calculated as the desired height of the
outermost point of the awning (A) plus 0.17
× the awning’s drop (here 0.17×250 cm =
43 cm).
If instead you want an angle of 60° in
relation to the wall, replace the constant of
0.17 in the calculation with 0.50 to get the
mounting height.
If instead you want an angle of maximum
45° in relation to the wall, replace the
constant of 0.17 in the calculation with 0.71
to get the mounting height.
The lowest point of the awning should be
at least 250 cm from the � oor when it is
unrolled.
There must be a clear space of 10 cm above
and 60 cm on each side of the awning once
it is � tted.
Unroll the template (11) and place it
horizontally on the wall where the awning
will go.
Drill holes into the wall for the wall brackets.
The holes must be 12 mm in diameter and
100 mm deep.
Insert the expansion bolts (15) into the
holes on the wall brackets (8) and press the
expansion bolts into the drilled holes.
Check that all brackets are in a horizontal
line in relation to each other.
Tighten the brackets by tightening the
expansion bolts with a spanner.