14
EN
!
It is always necessary to isolate the hood from the
power supply during cleaning and maintenance.
Therefore remove the plug.
We recommend carrying our maintenance regularly
(about every 10 days) to ensure efficacious and
constant performance of the hood.
Cleaning
The cooker hood should be cleaned regularly (at least
with the same frequency with which you carry out
maintenance of the fat filters) internally and externally.
Clean using the cloth dampened with neutral liquid
detergent. Do not use abrasive products. DO NOT USE
ALCOHOL!
WARNING:
Failure to carry out the basic cleaning
recommendations of the cooker hood and replacement
of the filters may cause fire risks.
Therefore, we recommend oserving these instructions.
The manufacturer declines all responsibility for any
damage to the motor or any fire damage linked to
inappropriate maintenance or failure to observe the
above safety recommendations.
Cleaning the grease filters
Traps cooking grease particles.
This must be cleaned once a month using non
aggressive detergents, either by hand or in the
dishwasher, which must be set to a low temperature
and a short cycle. When washed in a dishwasher, the
grease filter may discolour slightly, but this does not
affect its filtering capacity.
To remove the grease filter, pull the spring release
handle.
Cleaning the carbon filter
It absorbs unpleasant odours caused by cooking.
The charcoal filter can be washed once every two
months using hot water and a suitable detergent, or in
a dishwasher at 65°C (if the dishwasher is used, select
the full cycle function and leave dishes out).
Eliminate excess water without damaging the filter,
then remove the mattress located inside the plastic
frame and put it in the oven for 10 minutes at 100° C to
dry completely. Replace the mattress every 3 years
and when the cloth is damaged.
Mounting and changing the filter
Carbon filter
Remove the filter holder frame by turning the knobs (g)
90° that affix the chimney to the cooker hood.
Insert the pad (i) of activated carbon into the frame (h)
and fit the whole back into its housing (j).
Replacing lamps
Disconnect the hood from the electricity.
Warning! Prior to touching the light bulbs ensure they
are cooled down.
• Use a small screwdriver as a lever on the borders
of the lamp in order to remove the lightbulb.
• Slide out the lightbulb to be replaced and replace
with a new 12V 20W MAX 30° Ø35 12V GU4.
• Carry out the replacement and mount the new
lightbulb by following instructions in the reverse.
Maintenance
