SCHOLTES FN 36, Руководство по эксплуатации

Страница: 24 / 64

GB
2 4
C are an d m aintenance
Sw itc h in g t h e appliance o ff
Disconnect your appliance from the electricity
supply before carrying out any work on it.
C leaning the appliance
• The stainless steel or enamel-coated external
parts and the rubber seals may be cleaned using
a sponge that has been soaked in lukewarm water
and neutral soap. Use specialised products for
the removal of stubborn stains. After cleaning,
rinse and dry thoroughly. Do not use abrasive
powders or corrosive substances.
• The inside of the oven should ideally be cleaned
after each use, while it is still lukewarm. Use hot
water and detergent, then rinse well and dry with
a soft cloth. Do not use abrasive products.
• The accessories can be washed like everyday
crockery, and are even dishwasher safe.
Never use steam cleaners or pressure cleaners on
the appliance.
C leaning the oven door
Clean the glass part of the oven door using a
sponge and a non-abrasive cleaning product, then
dry thoroughly with a soft cloth. Do not use rough
abrasive material or sharp metal scrapers as these
could scratch the surface and cause the glass to
crack.
For more thorough cleaning purposes, the oven door
may be removed:
1. Open the oven door fully ( see diagram ).
2. Lift up and turn the small levers located on the
two hinges ( see diagram ).
3. (with glass panel fitted to
the inside of the door) Grip the
door on the two outer sides
and close it approximately
half way. Unlock the door by
pressing on the clamps . ,
then pull the door towards
you, lifting it out of its slot
( see diagram ).
To replace the door, reverse this sequence.
I nspecting t h e seals
Check the door seals around the oven at regular
intervals. If the seals are damaged, please contact
your nearest Service Centre ( see Assistance ). W e
recommend that the oven is not used until the seals
have been replaced.
Replacing the light b ul b
To replace the
oven light bulb:
1. Remove the glass cover using a screwdriver.
2. Unscrew the light bulb and replace it with a
similar one: W attage 15 W , cap E 14.
Replace the glass cover, making sure the seal is
positioned correctly ( see diagram ).
Assistance
W arning :
The appliance is fitted with an automatic diagnostic
system which detects any malfunctions.
Malfunctions are signalled through messages of the
following type: “<LETTERSPACE 0>F”, followed by
numbers.
Call for technical assistance in the event of a
malfunction.
Never use the services of an unauthorised
technician.
Please h a v e t h e f ollo w ing in f or m ation to h and :
• the type of problem encountered;
• the appliance model (Mod.);
• the serial number (S / N).
The latter two pieces of information can be found on
the data plate located on the appliance.
F
F
Glass door
Seal
Lamp
Oven
compartment