3 Assembly and start-up
SCHMIDT
®
TorquePress 520-560
– V2.1
13
Figure 5: Fastening options at the ram (example)
1
Dowel pin hole
2
Set screw
Lower tool
For mounting the lower tool, a table bore and a T-slot are available.
Place the lower tool on the table plate.
Screw the lower tool down to the table plate.
Figure 6: Frame with table plate (example)
1
Table bore
2
T-Slot
For frames with a screwed fixture mounting plate, the fixture mounting plate
is aligned with the ram but not pinned.
3.5 Adjusting the working area
Constructive restrictions
CAUTION
Damage to the press or to the tool
The available operating stroke is limited by various system functions (e.g.
initialization/ reference run, spindle lubrication, etc.). These system
functions move the ram above or below the topmost position.
Make sure that the execution of system functions does not result in
collisions with the tool or tools.
During tool construction, include a corresponding adapter in the
planning if necessary.
After the reference run, which is used to tare the force measurement, the
ram moves to the TDC position. The taring takes place via the spindle
rotation.
Ram extension at home
position
