4
ACCESSORY INSTALLATION BEFORE OPERATING
UNPACKING AND CLEANING THE APPLIANCE
•
Remove the exterior and interior packing materials.
•
Let the appliance stand upright for approximately 2 hours before connecting it to the power
source, which helps to reduce the possibility of a cooling-system malfunction from handling
during transportation.
•
Use a soft cloth to clean the interior surface with lukewarm water.
•
Install the door handle provided with the appliance.
•
This appliance is designed for free standing or built-in (fully recessed) installation.
•
This appliance is intended to be installed in a space between two units.
The minimum space required is:
JC95B/JC95W:
460mm wide × 605mm deep × 810mm high
JC132B/JC132W:
605mm wide x 605mm deep x 810mm high
Please note: When the product is installed, there should be a small ventilation gap between the top
of the unit and the underside of any fitting above (6mm or 1/4").
LOCK & UNLOCK THE DOOR (FOR OPTION)
•
Lock is fitted and key is attached in packing with this Manual.
•
Insert the key into the lock and turn it counter-clockwise to unlock the door. To lock it, please
follow the reversed operation. Please keep the key in safe location.
Installation of the Handle
To install the handle, please follow these instructions:
•
Carefully pull the door gasket (seal) away from the door in the area where the handle will be
attached.
•
Place the handle over the screw holes on the outside of the door and attach it with the screws that
have been provided. Tighten the screws.
•
Press the door gasket back into its groove.
REVERSING THE DOOR SWING
This appliance has the capability of the door opening from either the left or right side. The unit is
delivered to you with the door opening from the left side. Should you desire to reverse the opening
direction, please follow the instructions below:
1. Carefully lay the appliance on its back. Use cushioning to protect the floor and appliance.
2. Using a Philips screwdriver, remove the two screws and bottom right hinge beneath the door.
Keep the hinge in a safe place in case you need to reverse the door again in the future.
3. Carefully slide the door off and place it on a padded surface.
4. Remove the bottom support bracket from the right side.
5. Remove the top right hinge and keep in a safe place in case you want to reverse the door in the
future.
6. Remove the screws from the top left and transfer to the right.
7. Install the top left hinge.
8. Install the bottom left hinge to the door. Do not over-tighten the screw.
9. Rotate the door 180º and relocate it on the top hinge.
10. Install the bottom support bracket.
11. Adjust door alignment. When set, tighten screw on hinge.
Please note:
Keep the spare hinge plate(s) to be able to reverse the door back again.
