S
CHMALZ
SCPSb
5-11
5 M
AINTENANCE
G
ENERAL MAINTENANCE
E
XTERIOR SOILING
Remove dirt on the exterior of the device with a soft cloth and soap suds (max. 60°C). E n-
sure that the silencer and the controller are not soaked with soap suds.
S
ILENCER
Because it is open, the silencer may be exposed to high levels of dust, oil, etc., which may
dirty the silencer to the point of reducing the suction capacity. If this happens, it must be
replaced. Cleaning is not recommended due to the capillary effect of the porous material.
W
ARRANTY
,
SPARE PARTS AND WEARING PARTS
This system is guaranteed in accordance with our general terms of trade and delivery. The
same applies to spare parts, provided that these are original parts supplied by us.
We are not liable for any damage resulting from the use of non-original spare parts or ac-
cessories.
Wearing parts are not covered by the warranty.
The following list contains the primary spare and wearing parts.
S
PARE AND WEARING PARTS
Type
Designation
Article no.
Legend
Max. tightening torque
Silencer insert
10.02.02.04141
W
NO/NC
Pilot valve
„Blow-Off“
10.05.01.00104
S
0,2 Nm
NC
Pilot valve
„Suction“
10.05.01.00104
S
0,2 Nm
NO
Pilot valve
„Suction“
10.05.01.00103
S
0,2 Nm
Insulating plate
10.02.02.04152
S
Legend:
S
pare part=
S W
earing part=
W
When tightening the securing screws on the silencer module, observe the maxi-
mum tightening torque of 0,5 Nm.
When you replace the silencer insert, we recommend that you also replace the
insulating plate.
