Schluter Systems LIPROTEC LT ES 1, Инструкция по применению

Страница: 36 / 219

EN
Commissioning
Directions for use for LED strips 33
7 Commissioning
To commission the LIPROTEC system, proceed as follows:

Make sure all components are correctly mounted and connected as desired.

Switch on the mains power supply.

Make sure all LED strips light up.

If you use a Bluetooth receiver, you can now call the pre-programmed settings with
the remote control. For more information, read the "Commissioning" chapter in the
directions for use of the Bluetooth receiver.

Make sure the LIPROTEC system fundamentally works.

Connect all cable channels and cladding.

Your LIPROTEC system is now ready for daily use!
8 Operation
The LED strip does not having control or switch elements.
If you have switched a receiver between the power pack and LED strip, read the operating
instructions of the receiver.
9 Maintenance
Dirt must be cleaned off the LED strip if no spreading discs are used. No parts that have to
be maintained or exchanged are used.
To clean the LED strip, proceed as follows:

Switch off the LIPROTEC system.

Wipe contamination off the LED strip with a dry, non-linting, soft cloth.
10 Elimination of faults
Fault Cause of fault Troubleshooting
No lighting Connections mixed up Check all cable connections for a proper
connection
No voltage present Check the power pack for a proper
connection
Power pack overloaded Select a larger power pack (up to 150 W)
Receiver overloaded Check the maximum load of the respective
connections on the receiver. The LED strips
might have to be distributed over the
respective connections (observe the
maximum load of the respective