11
Apply one thin layer of BIOPLAST
®
insula-
ting agent only to those parts of the model
which will be covered by the mouthguard.
Trim model flat and place on model plat-
form with the clear V-shaped part of the
BIOPLAST
®
XTREME PRO material cove-
ring the desired extension of the anterior
section (e.g. from 3-3). Make sure the side
of the label with the imprint is facing the in-
frared heater when fixing the material. Heat
the foil by setting the code or recommen-
ded heating time according to the instruc-
tions. Close pressure chamber and open
after cooling phase has elapsed.
11
BIOPLAST
®
XTREME PRO
Instruction manual
GB
1
