16
Rx700 Long Range
This receiver have improved input filter and makes it now even better attenuation for 900 - 1300 - 2400
video transmitters. This is virtually impossible to jam. The Rx700LR also have improved distance of the
servo connector and now all 12 can be mounted at the same time and no bending or problems.
The receiver have the following dimensions:
Width: 34 mm.
Length: 62 mm. including angled connector.
Height: 10 mm.
Weight: 16 gr.
The receiver uses a Double LNA (Low Noise Amplifier) frontend with fast signal switch so it uses the best
signal.
Two MCX connector coax dipole wire antennas come with each RX t – Weight: 5.4 grams each.
The extra pin in ch 12 connector is RSSI out. It’s now buffered so loading of the RSSI out is uncritical, 1k
ohm Zout. It is also filtered to avoid less jumpy OSD readings.
CH 12 connector is also PPM out when < 12ch are used (auto mode is the default).
PPM out is the same as sum-signal and this is off course fully compatible with MikroKopter controller board
and all RX types and models have this.
Sensitivity: -113dBm to -114dBm
Input supply voltage range: 4-6V (Rx uses 134mA at 5V)
Servo signal pulse output: 3.3V positive
Radio band: 433 & 444Mhz multi band and multi frequency hopping system.
Temperature range: -40C to +70C tested
