Schaerer Ambiente 1 SUSA, Руководство пользователя

Страница: 26 / 52

Operation
Danger!
When the boiling point is reached, the beverage may start to spill. During steam
delivery, ensure that the steam pipe remains immersed in the liquid.
4. Heat the liquid to the desired temperature. Ensure that the steam pipe is always
immersed in the liquid.
Hint: The deeper the sound, the higher the temperature of the heated liquid.
5. * Steam delivery ends as soon as a beverage temperature of approx. 158°F /
70°C (in the container) is reached.
End or cancel steam delivery. Press the
[ STEAM ] Button.
6. Place the container on a stable surface.
Danger!
The steam pipe is hot. Touch the steam pipe only at the rubber handle.
7. Clean the outside of the steam pipe with a wet and clean paper cloth.
8. Point the steam pipe towards the drip grid. Press the [ STEAM ] button twice in
short sequence to clean the inside of the steam pipe.
4.4.7 Ending operation / Switching off the espresso machine
If the espresso machine is not going to be used for longer periods, e.g. nights, it
should be switched to stand-by. In this mode, the boilers are not heated and no bev-
erages are available.
1. Do the daily cleaning ( see Chapter 5 "Daily cleaning" ).
2. Briefly press the [ Stand-by ] button; the display will go dark.
The following message is displayed:
<<Standby>>
4.5 Extended idle times
4.5.1 Extended idle time of up to 4 weeks (e.g. holiday close-down):
1. Do the weekly cleaning ( see chapter 5 "Weekly cleaning".
2. Set the machine first into stand-by mode: see 4.4.7 "Ending operation / Switch-
ing off the espresso machine" page 4-6
3. Close the fresh water supply tap.
4. Turn off the main switch, or disconnect the power supply (unplug).
5. Vacuum the espresso beans out of the containers.
6. On premises where the temperature can drop below zero, the boilers must be
emptied. To empty the boilers, ask a customer service authorized by the manu-
facturer for assistance.
Attention!
If you resume operation at later point in time, ensure that you open the water supply
first and only then switch on the power supply.
Page 4-6 BASO-1 SUSA - 02.04 - V02