6
Set-Up / Operation (continued)
To prepare models PVM18LC and PVM18 for
operation:
1.
Place
empty
cooler/tank in approximate location to be
misted. Carrying a full cooler/tank will be difficult as
it will weigh approximately 80 pounds.
2.
Fill cooler/tank with water (and ice, if desired).
3.
Place the fan/pump enclosure on the cooler/tank.
4.
Be sure the intake line and filter are in the bottom of
the cooler/tank.
5.
Fasten the straps to the handles on both sides of the
tank.
* Model PVM18LC does not include a tank. Since the
pump enclosure is specifically made to fit a 10 gallon Igloo
cooler, it must be used only with this type of cooler,
supplied by the user.
DO NOT USE THE PVM18LC
WITH ANY OTHER WATER RESERVOIR!
WARNING
TIP HAZARD
• Serious injury is possible.
• Support weight of fan with free hand when
moving cart.
• Do not fill tank before moving cart.
To prepare model PVM18C for operation:
1.
Assemble cart as described earlier.
2.
DO NOT FILL TANK BEFORE MOVING CART.
Water in tank will add extra weight (about 80 pounds)
and is likely to spill out when cart is tilted back. This
can also make the cart unstable and hazardous to
move.
3.
Carefully move assembled cart to desired location.
4.
Remove the pump enclosure and fill tank with water
(and ice, if desired). Replace the pump enclosure on
the tank. Be sure the intake line and filter are in the
bottom of the tank.
5.
Fasten the straps to the handles on both sides of the
tank.
• Never operate pump without water supply.
• If leaks are observed, turn pump off and tighten fittings by hand.
• Excessively hard water (high solids) can plug nozzles.
• A plugged filter caused by poor water quality can restrict flow to pump and cause permanent damage.
• Never allow "fog" from the nozzles to come in contact with surfaces. This can cause condensation and water will form
on those surfaces; redirect the fan to prevent this circumstance.
CAUTION
Intake line
Filter
actoolsupply.com
actoolsupply.com
