– 2 –
1.
Remove the machine screws from
the bottom of both inside legs (where
the treadle assembly is attached). Spread
the legs apart and remove the treadle
assembly. Be careful not to lose the barrel
nuts the machine screws were attached to.
(Located on the underside of the treadle
support.)
2.
Remove the screw holding the treadle
block in place next to the brake. Slide off
the brake pedal and treadle block.
BABY WOLF PARTS
4 – treadles
3 – regular spacers
1 – medium spacer
1 – small spacer
1 – treadle aid bar
1 – treadle aid dowel
26 – tie-ups
10 – rubber bands
2 – 1-1/4" screws for treadle aid bar
MIGHTY WOLF PARTS
4 – treadles
2 – regular spacers
2 – treadle blocks
2 – 1-1/2" screws
16 – tie-ups
3.
Slide in new treadles and spacers on
each side in order as shown in figure 1
for Baby Wolf, figure 2 for Mighty Wolf.
4.
Replace the treadle assembly by
spreading the inside legs apart and lining
up the leg holes with the pins on the ends
of the treadle supports. Secure by screw-
ing the machine screws back into the bar-
rel nuts. (You will need to hold the barrel
nuts in place as you begin to tighten the
screw.)
•
BABY & MIGHTY WOLF
A
dding
F
our
T
reAdles
REQUIRED TOOLS
Phillips screwdriver
Drill and 1/8" drill bit (Baby Wolf looms)
