Operating and maintenance instructions
Standards
Version 1.0
Page 54 of 56
12 Standards
The electric motors of Schabmüller GmbH are built according to the currently valid
rules of technology and are considered safe to operate. The basic safety and health
requirements of the applicable laws, standards and directives are applied in the design
and manufacture of the motor.
The motors are developed, manufactured and tested in accordance with the following
standards:
Standard
IEC
DIN
EN
VDE
Dimensioning and operational behaviour
60034-1
60034-1
0530 Part 1
Method for determining losses and
efficiency
60034-2
60034-2
0530 Part 2
Connection designations and direction of
rotation
0530 Part 8
IEC standard voltages
60038
60038
0175
Noise limits
60034-9
60034-9
0530 Part 9
Degrees of protection due to the overall
design of rotating electrical machines (IP
code) classification
60034-5
60034-5
0530 Part 5
Mechanical vibration of certain machines
with shaft heights 56 mm and higher -
Measurement, evaluation and limits of
vibration severity
60034-14
60034-14
0530 Part 14
60° centre holes; types R, A, B, and C
Centre holes 60° with thread for shaft
ends
332 Part 1
332 Part 2
Cylindrical shaft ends; dimensions,
nominal transmissible torques
748-1
Shaft extension run out and of mounting
flanges for rotating electrical machinery -
Tolerances, test
42955
Drive type fastenings without taper action;
parallel keys, keyways, deep pattern
6885-1
Cable glands for electrical installations
50262
Electrical requirements for battery-
powered trucks
1175
1175
Machinery Directive 2006/42/EC
