motion detection camera mode, press K1 or K2 key. Red and blue lights blink off six times, and has
instructed in the state.
8.
PC Camera:
To use the PC Camera (video camera) function, install the driver with a random
distribution. When it is connected to the computer and in boot mode, enter the PC Camera.
9.
To Charge the Camera/Battery:
Connect the computer USB connector products or charger to
recharge the camera when the battery is charging. The blue light turns into red and blue lights five
seconds after the flash alternately when the battery is fully charged, then blue lights. Note: The
camera built-in high-capacity polymer lithium battery, with no memory effect, can be used with the
charge, but the initial use of the first five, and then charge the battery to run out to saturation. To
start the battery at maximum capacity, access to standard working time.
10.
While Charging Camera Side:
In the off state, while connected the camera to the computer. After
five seconds, press the K2 key. The red light will flash and indicate it entered the standby mode.
Then you can take pictures, video, audio, and use the motion detection operation.
11.
Remote control instructions:
First open the key K1 normal boot. Dual bright red and blue lights will
flash. Five seconds after the blue light and red light flash, it enters standby mode.
12.
To Shoot a Single Recording:
In standby mode, click
.
The blue light flashes three times and
exterminate the state at the point
.
Press the record button to stop and save.
13.
To Take a Photo:
In the standby mode, click
.
The blue light and red light turn off. Take the
picture and save photo shoot out. Blue light, red light.
14.
To Shoot a Video:
In the standby mode, click
.
The red light flashes three times and exterminate
into the video button in the point
. Stop and save.
15.
To Use Motion Control:
In the standby mode, click
.
The red and blue lights flashing after four
to exterminate the state machine into motion detect moving objects in front of the blue light and
flashed into the motion detection recording, the key point
. Stop motion detection and save.
Enter standby mode.
16.
Remote operation prompt:
K1 key switch must be in a state of constant power to use remote
control.
17.
To Set the Recording Time:
The camera provides a video recording time displayed in the function
format of year – month – day hour:minutes:seconds. Will form a good computer connection via USB
cable connected to my computer and a “removable disk” drive letter. Open the Windows software
WordPad or Notepad (*.txt format). Input [Date] 2010/05/05 12:59:30. Name the file name:
time.txt. Save the file in the root directory of the removable hard drive. Disconnect the cable and
then reboot the video camera. The new modified time and date will be in the bottom right corner of
videos and photos. You can also use the machine to update the file stored in WriteTime.exe
recording time. The method of double-WriteTime.exe out to update the window in the mid-point
update.
EXCEPTION HANDLING
1.
When the camera batteries are low, the red lights will flash rapidly for about 3 seconds.
Automatically save the current image file and shut down if you continue to use the camera for
charging before use.
2.
If the camera stops working due to improper operation or other special situations, press the F4
key, reboot, and then use the camera.
