Scarlett Silver Line SC-VC80RW01, Инструкция по эксплуатации

Страница: 9 / 60

IM022
9 SC-VC80RW01
DUST BIN CLEANING
 Pull up the upper cover directly.

Take out the dust bin out of the vacuum cleaner.
 Open the lid of dust bin by putting your finger into the dust bin groove and gripping to take it out

Take out the inner filter

Empty the dirt in the dust bin

Rinse the dust bin with tap water. Do not wash it in washing machine, dish-washing machine or other
machine.

Periodically clean the filter with a soft bristle brush.

Reinstall the filter and the dust bin lid once they get dried.
 Put back the dust bin into the cleaner
ATTENTION:

After repeated use for some time, dirt and dust might accumulate around the intake of the product, to
ensure its best cleaning efficiency and constant airflow it should be cleaned periodically Vacuum cleaner
or cord should never be immersed into water or any liquids.

WARNING!

Be sure to clean the container after each cleaning.
 Never use the vacuum cleaner without installed filter and with damaged or dirty filter. Otherwise, dust will
fall into the motor and cause damage to the vacuum cleaner.

Don’t use the vacuum cleaner if the container is filled to the mark “MAX”. When the container is filled,
dirty air clogs up the vacuum cleaner filter and the engine can overheat and disable.

Don’t use the vacuum cleaner for cleaning of material debris such as cement, whitewash, plaster, metal
shavings and etc. These particles cause to the engine damage.

Don’t wash vacuum cleaner parts in a dishwasher or a construction machine.
BATTERY REMOVAL

The battery must be removed from the appliance before its disposal.

When removing the battery, the appliance must be disconnected from power supply.
STORAGE

Fulfil all the steps from parts CARE AND CLEANING.

Store the unit in dry cool place or in the original box.
TROUBLESHOOTING

If all solutions given above
don’t work for you, please re-set the robot by switching on the power button
Problem Possible Cause Solution
Red LED stays after power
on
1. Battery Low condition
2. Main body is picked up
1. Recharge the battery
2. Re-place the robot on the floor
Vacuum on but can not
collect dirt and hair
1. The dust bin is full
2. The filter is not
installed correctly
1. Clean the dust bin
2. Re-install the filter correctly
The product is moving
backwards after being
started
1. The product is on dark
color floor
2. Anti-drop sensor light
was covered
1. Put the robot on light color floor.
2. Clean anti-drop sensor light.