Scarlett Silver Line SC-HC63C11, Инструкция по эксплуатации

Страница: 6 / 36

IM022
www.scarlett.ru SC-HC63C11 6

In its lowest position, the lever will leave the hair approximately the same l
ength as a №1
(3mm) comb.

The lever will also extend the use of your blades since a different cutting edge is used in each
setting.

In addition, if extremely heavy hair cutting has jammed the blades, it will help you to remove
hair that has become wedged between the two blades without removing the blades.

While the clipper is running rapidly move the lever from “close cut” to “longer cut” a couple of
times. Do this each time after you have finished using your clipper to keep the blades free of
cut hair.

If this does not help and clipper stops cutting, blades are dulled. Replace them with new
blades.
INSTRUCTIONS FOR HAIR CUTTING

Before starting the hair cut inspect the clipper, making sure that there is no oil between the
cutting blade teeth, switch the unit on to distribute the oil between the blade teeth and to check
running smoothness. Wipe off any excess oil. This should be done after each use. While using
the unit, untwist the cord from time to time to avoid tangling.

Before cutting always comb the hair thoroughly first.
DETACHABLE COMBS
Attachment
comb №
Hair length mm/inches
№1
3 (1/8)
№2
6 (1/4)
№3
9 (3/8)
№4
12 (1/2)

Each comb attachment is marked accordingly on its outside middle surface.

To attach a comb, hold it with its teeth upward and slide onto and along the clipper blade until
the front of the comb firmly seats against the clipper blade.

When you use the clipper for the first time, cut only small portions of hair.

For even cutting do not force the clipper. Also remember to comb the hair more frequently to
remove trimmed hair and check for uneven strands.

It is recommended that you start the haircut by choosing the maximum hair length, and then
gradually reduce the length setting.

In order to obtain the most effective result move the device in the direction opposite to the
direction of hair growth.
Since hair in different head segments grows in different directions, you need to move the
device in different directions as well (up, down or crosswise). See Figures 2.1-2.8.

In order to obtain a good haircut for wavy, rare or long hair, use a comb to direct the cutting
block of the device. See Figure 2.6.
CARE AND CLEANING

Switch off the appliance and unplug it.

Clean and oil the appliance after each use.

Remove cut hair from the clipper with the brush enclosed.

Wipe the clipper with a dry soft cloth.

Oil the blades as mentioned above.
STORAGE

Keep the appliance in a dry place.

You may hang the cutter by provided loop.

The blades must be oiled for storage period.
The symbol on the unit, packing materials and/or documentations means used electrical
and electronic units should not be toss in the garbage with ordinary household garbage. These
units should be pass to special receiving point.
For additional information about actual system of the garbage collection address to the local
authority.
Valid utilization will help to save valuable resources and avoid negative work on the public
health and environment which happens with incorrect using garbage.